Spinning Sprockets Ring

Created by Susan Johnson

Simple sprockets and game spinners give this ring an industrial look and at the same time so much fun to play with!
 

Supplies:

Flat Circle Ring, Amate Studios

Game Spinners, Tim Holtz-Advantus

Sprocket Gears, (One package will make up to 4 rings) Tim Holtz-Advantus

Dazzle Tac Jewelry Glue, Beacon

Glossy Accents, Ranger

Directions:

1. Layer three Sprocket Gears with the largest gear on the bottom.

2. Add a Game Spinner on top of the gears.

3. Attach the Game Spinner and Sprocket Gears together with a brad that comes with the Game Spinners. Tip: When opening up the brad, do not make it tight. Leave just a little bit of room. If it is too tight the gears will not spin.

4. Use Dazzle Tac Jewelry Glue place a small amount of glue to the center of the bottom gear and then add a very small amount of glue to the edges of the largest gear.

5. Attach the gears to the flat circle ring. You will need to hold the pieces together for a couple of minutes to adhere. Do not worry if there is a small gap around the base of the gears. We will fix that later.

6. Set aside to completely dry.

7. With Glossy Accents put a small line around the base of the gears to fill in any small gap. This is for extra stability and a finishing touch. Set aside to dry